Kingprint TMC2208 V2.1 Stepper Damper with Heat Sink Driver, Replacement Damper for A4988 DRV8825 for 3D Printer (4 Pieces)

Price: $24.99
Product prices and availability are accurate as of 2020-04-05 06:48:32 UTC and are subject to change. Any price and availability information displayed on http://www.amazon.com/ at the time of purchase will apply to the purchase of this product.
Availability: Not Available - stock arriving soon
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED 'AS IS' AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.

Manufacturer Description

NOTE

1.Hardware selection When using the UART working mode, carefully use the soldering iron to prevent burns, handle After observing, carefully observe whether the module has residual tin slag. It must be cleaned to prevent it.Cause the module to be short-circuited and burned;

2. Pay attention to the line sequence and IO port when wiring. Connecting the wrong line will directly cause the driver to not work.

3When plugging the driver into the motherboard, pay attention to see the driving direction, do not insert the wrong direction, and prevent the drive was burned.

4.Be sure to do the heat dissipation work (heat sink + cooling fan) before driving to prevent driving not working properly

If you encounter other problems in use, please contact us, we will be careful answer for you; if you have any good comments or suggestions on our products, you are welcome to return tell us, we will carefully consider your comments or suggestions, thank you for choosing kingprint products, thank you!

Packaging includes:
4 x TMC2208 V2.1.
4 x heat sink.

Product Features

TMC2208 V2.1 motor current can be arbitrarily set by firmwarev Microsteps can be set arbitrarily by firmware (up to 256 actual microsteps) When the motor is not moving, the motor standby current can be dynamically reduced (via UART)

Write a Review