Pangding 5Pcs TMC2208 V1.2 Stepstick Stepper Motor Driver Module Carrier 3D Printer Accessories with Heat Sink Screwdriver

Price: $36.29 $34.48
Product prices and availability are accurate as of 2020-08-30 01:54:09 UTC and are subject to change. Any price and availability information displayed on https://www.amazon.com/ at the time of purchase will apply to the purchase of this product.
You Save: $1.81 (5%)
Availability: In Stock
In Stock.
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED 'AS IS' AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.

Product Features

TMC2208 is an ultra-quiet two-phase stepper motor driver chip with continuous drive current of 1.4A, peaks current of 2A, voltage range of 4.75V-36V, and 256 subdivision. Compatible with existing 3D printer electronics, eliminating the costly redesign. UART configuration interface (9600 ... 500k Baud) The flexible microPlyer interpolation unit provides up to 256 subdivisions for perfect sinusoidal control even in systems with limited pulse frequency. These are also because the stealthChop2 ultra-quiet technology is widely used for 3D printing. CoolStep current dynamic adjustment technology can save 70% energy. DcStep, stallGuard2 stall detection technology Use the standard step / dir interface. Easy to use. It can replace the original TMC2100 and reduce heat generation, especially for the 3D printing market. With this adapter, you can test the SilentStepStick or flash the TMC2208 SilentStepStick using a USB to serial converter. StealthChop2 mute technology, faster motor acceleration/ deceleration than stealthChop The adapter has a stackable connector so you can use it directly on the 3D printer board. The tester is pre-configured to operate independently on a USB-to-serial adapter (VIO-VM jumper off). SpreadCycle - high dynamic motor control chopper, automatic stealthChop and spreadCycle switching depending on speed Setup: Using the TMC2208 Configurator, you can change settings via the UART interface and program the Trinamic TMC2208's OTP (One Time Programmable) memory. Hardware compatible with StepStick and Pololu A4988 stepper drives. Components on the bottom PCB side for better heat dissipation. Automatic standby current reduction